How to remove the front and rear bumper AUDI A7
26-03-2023, 04:37. Posted by: carsoftos777
The bumper is removed along with the grille.
-under the hood take out the caps and remove the trim over the grille.
-Unscrew the screws under the trim (spun down).
-Unscrew the screws around the perimeter at the bottom (spun up).
-turn the wheels to the left or right side, depending on which side we will disassemble first.
-in the wheel wells, Unscrew the screws and take out the caps that secure the fender liner.
-under the left fender liner, disconnect the headlight washer hoses. To prevent liquid from leaking to the ground, you need to prepare a suitable container or plug.
-move the fender liner to the side and Unscrew the screws that attach the corners to the wings.
-with an assistant, tear off the corners from the latches in the wings and pull the bumper from the rails towards you.
-remove the connector from the parking sensors (if any).
-remove the connector from the fog lights.
-remove connectors from additional electrical equipment (depending on the configuration of the car).
Rear bumper
-open the trunk lid and remove the lining of the rear lights.
-under the overlays, Unscrew two nuts on each side and remove the rear lights (held by latches).
-under the rear lights, through a special hole, you need to hook and pull up the blocking tire.
-in the trunk, remove the side trim.
-under the skins, using the head, unscrew one nut on each side and remove the connectors from the additional electrical equipment (depending on the configuration of the car).
-Unscrew the screws in the wheel arches that secure the fender liner (in order not to remove the wheels it is more convenient to unscrew with a ratchet with a nozzle).
-move the fender liner to the side and Unscrew one screw on each side.
-Unscrew the screws around the perimeter at the bottom (spun up).
-with an assistant, we release the bumper from the latches in the wings and pull it from the guides towards ourselves.
come back