How to remove the front and rear bumper AUDI Q7
7-03-2023, 03:19. Posted by: carsoftos777
on vehicles with “ACC”, remove the heated badge bracket.
-under the hood take out the caps and remove the cover of the radiator frame.
-under the cover, Unscrew the upper bolts that secure the grille and the upper part of the bumper to the body.
-at the very bottom of the bumper along the entire length, Unscrew the screws that secure the engine protection and fender liner.
-Unscrew the wheels left or right, depending on which side of the bumper will be unscrewed first.
-in the wheel arches, Unscrew the screws and take out the caps that attach the fender liner to the bumper.
pull the bumper off the side latches.
-carefully pull the bumper towards you.
-Now you can disconnect the connectors from the fog lights.
- if there are headlight washers, disconnect the hoses from the injectors and close them with stoppers so that no liquid flows out of the reservoir.
-remove the bumper
Rear bumper
[b]Caution!
On vehicles with lane change assist (audisideassist), additionally note the following. If the removed rear bumper is reinstalled or changes are made to the rear bumper, then the lane change assistant (audisideassist) should be calibrated [/ b]
-in the wheel arches, unscrew the screws and take out the clips (in order not to remove the wheels, you can use a ratchet with a nozzle).
-along the entire length of the lower part of the bumper, we take out the clips (usually four in the middle and one at the edges).
-remove the trim in the trunk.
-from the trunk, approximately under the rear lights, Unscrew two nuts on each side.
-if there is parking sensors, you need to disconnect the common connector
(on the left under the rear light).
-remove the edges of the bumper from the rails.
- Pull the bumper over.
come back