How to remove the front and rear bumper of a Chevrolet Captiva
18-01-2023, 03:10. Posted by: carsoftos777
-under the hood take out the caps that secure the trim and Unscrew the two screws that secure the top.
-turn the wheels to the left or right side, depending on which side we will disassemble first.
-in the wheel wells, Unscrew the screws that secure the fender liner.
-remove the fender liner to the side and Unscrew one screw on each side (spun up) that attach the corners of the bumper to the wings.
-on the perimeter at the bottom, Unscrew the screws (spun up).
-with an assistant, release the corners from the latches in the wings (pull towards you).
-pull the bumper forward.
-remove the connector from the fog lights (if any).
-if there are headlight washers, disconnect the hoses (so that the liquid does not leak to the ground, a special container should be prepared).
Rear bumper
-Open the trunk lid.
-remove the rear lights.
-take out the caps under the rear lights.
-Unscrew the screws in the opening of the trunk.
-Unscrew the screws and take out the caps at the bottom (twisted and inserted from the bottom up).
-Unscrew the screws in the wheel arches and release the fender liner.
-for the fender liner, Unscrew one screw on each side that attach the corners to the wings (spun up).
-with an assistant, release the latches in the wings (pull the corners towards you).
-remove the bumper from the guides back.
-remove the connector from the parking sensors (if any).
come back